Preview

Building and Reconstruction

Advanced search

COMPARATIVE BENDING AND WIDTH OF OPENING OF CRACKS OF REINFORCE-CONCRETE BEAM ON HOME NORMS AND EUROCODE 2

Abstract

In the article the analysis of results of calculation of reinforce-concrete beam is presented on second group of the maximum states on home norms and Eurocode 2. Experimental data over are brought on bending of reinforce-concrete beam and width of opening of normal cracks. Experimental samples are presented - beams of rectangular cross section with dimensions of 10cm x 20cm and length of 220cm.Their comparative analysis is produced with the results of calculations on home norms and Eurocode 2. The curvature of the reinforced concrete element without cracks in Eurocode 2 is determined. Under operational loads, satisfactory convergence of the calculated values of the opening width of normal cracks is observed. The deviation is within 5%. Experimental values of the width of the opening of normal cracks on the entire range of stresses in the reinforcement are 1.2 ... 1.4 times lower than those calculated by domestic and foreign standards.

About the Author

A. D. Istomin
Moscow state construction university
Russian Federation


References

1. Алмазов, В.О. Проектирование железобетонных конструкций по Евронормам [Текст]. - М.: АСВ, 2011. - 215 с.

2. Колмогоров, А.Г. Расчет железобетонных конструкций по российским и зарубежным нормам [Текст]: учебное издание / А. Г. Колмогоров, В. С. Плевков. - М.: Изд-во ABC, 2014. - 512 с.

3. Биби, Э.В. Руководство для проектировщиков к Еврокоду 2: Проектирование железобетонных конструкций [Текст]. / Э.В. Биби, Р.С. Нараянан. - М.: МГСУ, 2013. - 292 с.

4. Тамразян, А.Г. Особенности расчета изгибаемых железобетонных элементов прямоугольного сечения согласно EC2 // Бетон и железобетон. - 2012. - № 1. - С.19.

5. Тамразян, А.Г. Бетон и железобетон: проблемы и перспективы // Промышленное и гражданское строительство. - 2014. - № 7. - С.51-54.

6. Тамразян, А.Г. К остаточной несущей способности железобетонных балок с трещинами / А.Г. Тамразян, М.А. Орлова // Жилищное строительство. - 2015. - № 6. - С. 32-34.

7. Кабанцев, О.В., Тамразян А.Г. Учет изменений расчетной схемы при анализе работы конструкции / О.В. Кабанцев, А.Г. Тамразян // Инженерно-строительный журнал. - 2014. - № 5 (49). - С. 15-26.

8. Тамразян, А.Г. О влиянии снижения жесткости железобетонных плит перекрытий на несущую способность при длительном действии нагрузки / А.Г. Тамразян, Е.А. Филимонова // Промышленное и гражданское строительство. - 2012. - № 7. - С. 30-32.

9. СП 63.13330.2012. Актуализированная редакция СНиП 52-01-2003 Бетонные и железобетонные конструкции. Основные положения [Текст]. - М., 2012. - 156 с.

10. EN 1992-1-1: 2004. Eurocode 2: Design of concrete structures - Part 1-1: General rules and rules for buildings. Brussels. 2004. - 226 p.

11. Истомин, А.Д. Работа статически неопределимых железобетонных элементов в условиях отрицательных температур / А.Д. Истомин, А.В. Кудрявцев // Промышленное и гражданское строительство. - 2016. - № 7. С. 51-55.


Review

For citations:


Istomin A.D. COMPARATIVE BENDING AND WIDTH OF OPENING OF CRACKS OF REINFORCE-CONCRETE BEAM ON HOME NORMS AND EUROCODE 2. Building and Reconstruction. 2018;(1):31-37. (In Russ.)

Views: 284


Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 License.


ISSN 2073-7416 (Print)