Strength of bending concrete filled steel elements of improved design
https://doi.org/10.33979/2073-7416-2024-116-6-37-47
Abstract
An improved design of concrete filled steel tube element of rectangular cross-section subjected to bending has been proposed, which has greater strength and requires significantly greater energy consumption for destruction compared to known analogues. To test the effectiveness of the proposed design, experimental studies were carried out on the strength of normal sections and the beam rigidity of concrete filled steel tube beams under four-point bending. Research has shown that by simultaneously strengthening the compressed and tensile zones, it was possible to increase the strength of normal sections of beams. The increase in strength of beams of the improved design averaged 42%. The rigidity of non-reinforced concrete filled steel tube beams turned out to be significantly higher compared to beams without filling the steel pipe with concrete. In the improved beams, the stiffness was still approximately 20% higher. The results of comparing the calculated strength of concrete filled steel tube beams using the limit force method with experimental data indicate their satisfactory agreement.
About the Authors
A. L. Krishan
Magnitogorsk State Technical University named after G.I. Nosov
Russian Federation
Russian Federation
Doctor of Sciences (Engineering), Professor, Adviser of RAACS, Professor of the Department of Design and Construction of Buildings
Magnitogorsk
V. D. Kolesnikov
Magnitogorsk State Technical University named after G.I. Nosov
Russian Federation
Russian Federation
Postgraduate student of the Department of Design and Construction of Buildings
Magnitogorsk
V. I. Rimshin
Scientific-Research Institute of Building Physics of RAACS
Russian Federation
Russian Federation
Doctor of Sciences (Engineering), Professor, Corresponding Member of RAACS
Moscow
M. A. Astafeva
Magnitogorsk State Technical University named after G.I. Nosov
Russian Federation
Russian Federation
Candidate of Sciences (Engineering), Docent of the Department of Design and Construction of Buildings
Magnitogorsk
M. A. Likhidko
Magnitogorsk State Technical University named after G.I. Nosov
Russian Federation
Russian Federation
Postgraduate student of the Department of Design and Construction of Buildings
Magnitogorsk
References
1. Krishan A.L., Rimshin V.I., Astafieva M.A. Szhatyye trubobetonnyye elementy. Teoriya i praktika [Compressed pipe concrete elements. Theory and practice]. Moscow: ASV. 2020. 375 p.
2. Rimshin V.I., Krishan A.L., Astafieva M.A. Self-jamming elements in pipe-concrete columns. Academia. Arkhitektura i stroitel'stvo. 2023. No. 3. Pp. 140—148. (rus). [Online]. URL: https://doi.org/10.22337/20779038-2023-3-140-148 (date of application: 27.06.2024).
3. Rimshin V.I., Anpilov S.M., Krishan A.L., Astafieva M.A., Stupak A.A. Strength of short tube-concrete columns of square section. Russkii in zhener. 2023. No. 2 (79). Pp. 46—48. (rus).
4. Krishan A.L., Rimshin V.I., Astafieva M.A., Sagadatov A.I., Semenova M.N., Stupak A.A. Strength and deformability of compressed tube-concrete elements of square section. BST. 2022. No. 6 (1054), pp. 16–18.(rus).
5. Krishan A.L., Surovtsov M.M. Experimental reserches of strength of flexible concrete-filled tube (CFT) columns. Vestnik of Nosov Magnitogorsk State Technical University. 2013. No. 1(41). Pp. 90-92. (rus).
6. Ahmed M., Liang Q.Q., Patel V.I., Hadi M.N.S. Numerical analysis of axially loaded circular high strength concrete-filled double steel tubular short columns. Thin-Walled Structures. 2019. (138). Pp. 105–116. URL: https://doi.org/10.1016/j.tws.2019.02.001. (date of application: 27.06.2024).
7. Du, G.; Andjelic, A.; Li, Z.; Lei, Z.; Bie, X. Residual Axial Bearing Capacity of Concrete-Filled Circular Steel Tubular Columns. Applied Sciences. 2018. No. 8 (793). URL: https://www.mdpi.com/2076-3417/8/5/793/htm (date of application: 27.06.2024).
8. Ge H.B., Usami T. Strength analysis of concrete-filled tin-walled steel box columns. Journal of Constructional Steel Research. 1994. Pp. 259-281.
9. Han, L.-H., Lam, D., & Nethercot, D. Design Guide for Concrete-filled Double Skin Steel Tubular Structures (1st ed.). CRC Press. URL: https://doi.org/10.1201/9780429440410. (date of application: 27.06.2024).
10. Hassanein M.F, Elchalakani M., Patel V.I. Overall buckling behaviour of circular concrete-filled dual steel tubular columns with stainless steel external tubes. Journal Thin-Walled Structures. 2017. No. 115. Pp. 336–348.
11. Kibriya T. Performance of Concrete Filled Steel Tubular Columns. Аmerican Journal of Civil Engineering and Architecture. 2017. No. 5(2). Pp. 35–39.
12. O'Shea M.D., Bridge R.Q. Design of circular thin-walled concrete filled steel tubes. Journal of Structural Engineering. 2000. No. 126(11). Pp. 1295–1303.
13. Uy B., Tao Z., Han L.H. Behaviour of short and slender concrete-filled stainless steel tubular columns. Journal of Constructional Steel Research. 2011. No.67. Pp. 360-378.
14. Abed F.H., Abdelmageed Y.I., Ilgun A.K. Flexural response of concrete-filled seamless steel tubes. Journal of Constructional Steel Research. 2018. No.149. Pp. 53–63.
15. Jiang A., Chen J., Jin W-L. Experimental investigation and design of thin-walled concrete-filled steel tubes subject to bending. Thin-Walled Structures. 2013. No. 63. Pp. 44–50.
16. Gho W.M., Liu D. Flexural behavior of high-strength rectangular concrete- filled steel hollow sections. Journal of Constructional Steel Research. 2004. No.60. PP.1681–96.
17. Guochang Li, Di Liu, Zhijian Yang, Chunyu Zhang. Flexural behavior of high strength concrete filled high strength square steel tube. Journal of Constructional Steel Research. 2017. No.128. Pp. 732–744.
18. Han L.-H., Lu H., Yao G.-H., Liao F. Further Study on the Flexural Behavior of Concrete-filled Steel Tubes. Journal of Constructional Steel Research. 2006. No.62(6). PP. 554-565.
19. Hemzah S.A., Al-Obaidi S., Salim T. Flexural behavior of concrete filled steel tube composite with different concrete compressive strength. International Journal of Civil Engineering and Technology. 2018. No. 9(7). Pp. 824–832.
20. Ming-Xiang Xiong, De-Xin Xiong, J.Y. Richard Liew. Flexural performance of concrete filled tubes with high tensile steel and ultra-high strength concrete. Journal of Constructional Steel Research. 2017. No. 132. Pp. 191– 202.
21. Tomii, Masahide and Kenji Sakino. Elasto-plastic behavior of concrete filled square steel tubular beamcolumns. Transactions of the Architectural Institute of Japan. 1979. No.280. Pp. 111–20.
22. Uy B. Strength of short concrete filled high strength steel box columns. Journal of Constructional Steel Research. 2001. No.57. Pp. 113–34.
23. Wang R., Han L-H., Nie J-G., Zhao X-L. Flexural performance of rectangular CFST members. Thin-Walled Structures. 2014. No.79. Pp.154–165.
24. Arleninov, P.D., Krylov PP.B., Smirnov P.P. Calculation of the central and eccentrically compressed pipeconcrete structures strength. Sejsmostojkoe stroitel`stvo. Bezopasnost` sooruzhenij. 2017. No. 4. Pp. 34-38. (rus).
25. Khazov P.A., Pomazov A.P. Experimental study of longitudinal and transverse bending of pipe concrete rods. Zhilishhnoe stroitel`stvo. 2023. No. 12. Pp. 66–71. (rus).
26. Yakupova L.Z., Astankov K.Yu., Ovchinnikov I.G. The code of norms SP 266.1325800.2016 "Composite steel and concrete structures. Design rules" applicability for the low-span bridges made of concrete-filled steel tubes design. Transport. Transportny`e sooruzheniya. E`kologiya. 2023. No. 2. Pp. 112-121. (rus).
27. American Institute of Steel Construction. Specification for Structural Steel Buildings ANSI/AISC 360-10. American Institute of Steel Construction. 2010.
Review
For citations:
Krishan A.L., Kolesnikov V.D., Rimshin V.I., Astafeva M.A., Likhidko M.A. Strength of bending concrete filled steel elements of improved design. Building and Reconstruction. 2024;(6):37-47. (In Russ.) https://doi.org/10.33979/2073-7416-2024-116-6-37-47
Views:
111
Email this article 