Stiffness of reinforced concrete structures under bending considering shear and axial forces (part 2)
https://doi.org/10.33979/2073-7416-2024-112-2-16-27
Abstract
The paper presents a physical and computational model for determining the parameters of limit states of reinforced concrete structures under complex stressed state - bending with axial and shear forces. Based on the adopted scheme of cross-section discretization and A.R. Rzhanitsyn's theorem of duality between force and deformation parameters, the forward and backward transfer for determining the coefficients of the stiffness matrix of reinforced concrete rod structures with inclined and normal cracks have been constructed. Stiffness of structures in the zone of inclined cracks is determined using the model of composite strips which separate the zone with inclined cracks. The hypothesis about the character of deformation distribution in a complex-stressed reinforced concrete element with inclined cracks is accepted.
For this model the conditional shear modulus is obtained, which allows to determine the average relative linear and angular strains of concrete and reinforcement at the point adjacent to the shear joint between inclined cracks. Based on this model and using the experimentally obtained value of the relative shear in the inclined crack, the dowel forces in the reinforcing bar intersected by the inclined crack were determined. The application of the obtained analytical relationships in the practice of designing reinforced concrete structures allows not only to clarify significantly the definition of displacements and width of opening of inclined and normal cracks, but also to maximize the convergence of the design and physical model based on experimental data.
About the Authors
Vl. I. Kolchunov
National Research Moscow State University of Civil Engineering;
Scientific Research Institute of Construction Physics of the Russian Academy of Architecture and Construction Sciences
Russian Federation
Russian Federation
Kolchunov Vladimir Iv. - Corresponding Member of the Russian Academy of Architecture and Construction Sciences, doctor of technical sciences, professor, professor of the Department of Engineering Graphics and Computer Modeling;
Moscow
S. B. Krylov
Gvozdev Research Institute of Reinforced Concrete, JSC SIC Construction
Russian Federation
Russian Federation
Krylov Sergey B. - Corresponding Member of the Russian Academy of Architecture and Construction Sciences, doctor of technical sciences, professor, head of the Reinforced Concrete Mechanics Laboratory at the Gvozdev Research Institute for Reinforced Concreteб
Moscow
S. S. Fedorov
National Research Moscow State University of Civil Engineering
Russian Federation
Russian Federation
Fedorov Sergey S. - candidate of technical sciences, head of the Department of Engineering Graphics and Computer Modeling,
Moscow
References
1. Arzamastsev S.A., Rodevich V.V. To the calculation of reinforced concrete elements for bending with torsion. Proceedings of higher educational institutions. Building. 2015. vol. 681. no. 9, Pp. 99-109.
2. IlkerKalkan, SaruhanKartal. Torsional Rigidities of Reinforced Concrete Beams Subjected to Elastic Lateral Torsional Buckling. International Journal of Civil and Environmental Engineering. 2017. Vol. 11. No.7. Pp. 969–972.
3. G. Klein, G. Lucier, S. Rizkalla, P. Zia and H. Gleich. Torsion simplified: a failure plane model for desigh of spandrel beams. ACI Concrete International Journal. 2012. February. Pp.1-19
4. Lin W. Experimental investigation on composite beams under combined negative bending and torsional moments. Advances in Structural Engineering. 2021. 24(6). Pp. 1456–1465. DOI: 10.1177/1369433220981660.
5. Zalesov A.S., Mukhamediev T.A., Chistyakov E.A. Calculation of crack resistance of reinforced concrete structures according to new normative documents. Concrete and Reinforced Concrete. 2002. No. 5. Pp. 15-18.
6. Kodysh E.N., Nikitin I.K., Trekin N.N. Calculation of reinforced concrete structures from heavy concrete on strength, crack resistance and deformations. Moscow: Publ. ASV, 2010. 352 p.
7. Krylov S.B. Construction of the exact general solution of the bending equation of a reinforced concrete rod with account of creep and cracking. Concrete and Reinforced Concrete in Ukraine. 2002. No. 4(14). Pp. 2-4.
8. Travush V.I., Karpenko N.I., Kolchunov Vl. I., Kaprielov S.S., Demyanov A.I., Konorev A.V. Main results of experimental studies of reinforced concrete structures of high-strength concrete B100 round and circular cross sections in torsion with bending. Structural Mechanics of Engineering Constructions and Buildings. 2019. vol. 15. no. 1. Pp. 51-61. DOI:10.22363/1815-5235-2019-15-1-51-61
9. Demyanov A.I., Salnikov A.S., Kolchunov Vl. I. The experimental studies of reinforced concrete constructions in torsion with bending and the analysis of their results. Building and Reconstruction, 2017. vol. 72, no. 4. Pp. 17–26.
10. Kolchunov V.I., Al-Hashimi O.I., Protchenko M.V. Bending stiffness of reinforced concrete structures with transverse and longitudinal forces. Building and reconstruction. 2021. No. 6. Pp. 5-19.
11. Kolchunov Vl. I., Fedorov V.S. Conceptual Hierarchy of Models in the Theory of Resistance of Building Structures. Industrial and Civil Engineering. 2020. No. 8. Pp. 16–23, DOI: 10.33622/0869-7019.2020.08.16-23.
12. Kolchunov V. I., Dem'yanov A. I. The modeling method of discrete cracks and rigidity in reinforced concrete. Magazine of Civil Engineering. 2019. vol. 88. no. 4. р. 60-69, DOI: 10.18720/MCE.88.6.
13. Karpenko N. I., Kolchunov Vl. I., Travush V. I. Calculation model of a complex stress reinforced concrete element of a boxed section during torsion with bending. Russian Journal of Building Construction and Architecture. 2021. vol. 51. no. 3. Pp. 7-26. DOI: 10.36622/VSTU.2021.51.3.001.
14. Gornostaev I.S., Klyueva N.V., Kolchunov Vl.I., Yakovenko I.A. Deformability of reinforced concrete composite structures with inclined cracks. Structural mechanics and calculation of structures. 2014. No. 5 (256). Pp. 60-66.
15. Gusev B.V., Zvezdov A.I. Theoretical and experimental studies of statistical issues of concrete strength. Construction Materials. 2017. No. 11. Pp. 18-21.
16. Bondarenko V.М., Kolchunov Vl.I. Design models of the power resistance of reinforced concrete. Moscow: Publishing house ASV, 2004. 471 p. 17. Veruzhsky Yu.V., Kolchunov Vl.I. Methods of reinforced concrete mechanics. Kiev: NAU Book Publishing House. 2005. 653 p.
17. Golyshev A.B., Kolchunov Vl.I. Reinforced concrete resistance. Kiev: Osnova, 2009.432 p.
18. Golyshev A.B., Kolchunov V.I. Soprotivlenie zhelezobetonnyh konstrukcij, vozvodimyh v slozhnyh inzhenerno-geologicheskih usloviyah [Resistance of reinforced concrete structures erected in complex engineeringgeological conditions] Kiev: Osnova, 2010. 286 p. (in Russian).
19. Emelianov s. G., Nemchinov Yu. I., Maryenkov N. G., Kolchunov Vl. I., Yakovenko I. A. Features of calculation of seismic stability of large-panel buildings. Promyshlennoe i grazhdanskoe stroitel'stvo. 2013. No. 12. Pp. 64–71. (in Russian).
20. Kim C., Kim S., Kim K.-H., Shin D., Haroon M., Lee J.-Y. Torsional Behavior of Reinforced Concrete Beams with High-Strength Steel Bars. ACI Structural Journal. 2019. 116. Pp. 251-233.
21. Velyuzhsky Yu.V., Golyshev A.B., Kolchunov Vl.I., Klyueva N.V., Lisitsin B.M., Mashkov I.L., Yakovenko I.A. A reference guide to structural mechanics: Volume II. Moscow: Publishing house ABC. 2014. 432 p.
22. Bashirov Kh.Z., Kolchunov Vl. I., Fedorov V.S., Yakovenko I.A. Reinforced concrete composite structures of buildings and structures. Moscow: ASV Publishing House, 2017.248 p.
23. Karpenko N.I. The theory of deformation of reinforced concrete with cracks. Moscow: Stroyizdat.1976. 204 p.
24. Karpenko N.I. General models of reinforced concrete mechanics. Moscow: Stroyizdat, 1996. 410 p.
25. Karpenko, S.N. On the general approach to the construction of the theory of strength of reinforced concrete elements under the action of transverse forces. Concrete and reinforced concrete. 2007. No. 2. Pp. 21-27.
26. Kolchunov V.I., Krylov S.B., Fedorov S.S. Stiffness of reinforced concrete structures under bending considering shear and axial forces (part 1). Building and Reconstruction. 2023. No. 6. Pp. 25- 40. https://doi.org/10.33979/2073-7416-2023-110-6-25-40
Review
For citations:
Kolchunov V.I., Krylov S.B., Fedorov S.S. Stiffness of reinforced concrete structures under bending considering shear and axial forces (part 2). Building and Reconstruction. 2024;(2):16-27. (In Russ.) https://doi.org/10.33979/2073-7416-2024-112-2-16-27
Views:
204
Email this article 